Page 1
UNiK A PROFESSIONAL POWER AMPLIFIER User Instructions This booklet contains important information concerning the proper and safe operation of your new amplifier.. Index PL-Series PL-300 / PL-500 Made in Taiwan 02 Introduction 03 Front Panel 04 Rear Panel 05 Set Up...
Page 2
IMPORTANT SAFETY INSTRUCTIONS PL-300/PL-500 This symbol is intended to alert the user to the presence of This symbol is intended to alert the user of non insulated "dangerous voltage" within the product's the presence of important operating and CAUTION enclosure that may be of sufficient magnitude to constitute...
Specifications IMPORTANT PRECAUTIONS INTRODUCTION To reduce the risk of electrical shock or fire, do not expose this unit rain or Congratulations and thank you for purchasing PL-300/PL-500 amplifiers. moisture. These amplifiers are representation of UNiKA’s continuing commitment to ...
Turning the knob in a clockwise direction will increase is being amplified. signal output. 8. UNiKA Logo and Model No - PL series have 2 types of 2U models PL- 300 / PL-500. page 3...
UNiKA PL-300/PL-500 Rear Panel Introduction Front Panel Set Up Speakon Assembly Operating Modes Protection Specifications PL-500 REAR PANEL INPUT CONNECTOR PINS CH1 INPUTS CH1 OUTPUTS BREAKER RING SLEEVE BARREL CAUTION LOCK RISK OF ELECTRIC SHOCK DO NOT OPEN OUTPUT CONNECTOR PINS...
Page 6
UNiKA PL-300/PL-500 Set Up Introduction Front Panel Rear Panel Speakon Assembly Operating Modes Protection Specifications SET UP INPUTS - The PL series allows you to use three types of input connectors per channel. A XLR female jack for balanced connections, a 1/4”...
Page 7
UNiKA PL-300/PL-500 Set Up Introduction Front Panel Rear Panel Speakon Assembly Operating Modes Protection Specifications BANANA PLUGS: (Figure 7) When connecting your speakers to the amplifier using banana plug, be sure that the red and black caps on the binding post are completely screwed in. Insert the banana plug into the caps of the binding post, be sure Figure that the banana plug is inserted securely to avoid the risk of popping out.
UNiKA PL-300/PL-500 Speakon Assembly Introduction Front Panel Rear Panel Set Up Operating Modes Protection Specifications SPEAKON ASSEMBLY: You will need a pair of Neutrik Speakon NL4FC connectors. You will also need high-quality two or four conductor Speakon cable, a pair of needle-nosed pliers...
UNiKA PL-300/PL-500 Operating Modes Protection Introduction Front Panel Rear Panel Set Up Speakon Assembly Specifications OPERATING MODES STEREO OPERATION: Connect your inputs into channel one and channel two of the amplifier. Connect your speakers to the outputs on the rear of the amplifier.
Page 10
UNiKA PL-300/PL-500 Protection Introduction Front Panel Rear Panel Set Up Speakon Assembly Operating Modes Specifications 2. OVERHEATING PROTECTION The PL series amplifiers are cooled by Single 2-speed fan, and always are kept at moderate temperature. During low level output the fans run at normal speeds.