Expansion Card - HP EliteDesk 705 G5 Maintenance And Service Manual

Expansion card

For a list of available expansion cards, see
The computer has one PCI Express ×1 expansion socket and one PCI Express ×16 expansion socket.
NOTE: The PCI Express sockets support only low profile cards.
You can install a PCI Express ×1, ×4, ×8, or ×16 expansion card in the PCI Express ×16 socket.
For dual graphics card configurations, the first (primary) card must be installed in the PCI Express ×16 socket.
Before removing expansion cards, follow these steps:
1. Prepare the computer for disassembly
2. Remove the access panel
Remove/replace, or add expansion cards:
1. Locate the correct vacant expansion socket on the system board and the corresponding expansion slot
on the back of the computer chassis.
2. Rotate the slot cover retention latch that secures the slot covers to the open position.
3. Before installing an expansion card, remove the expansion slot cover or the existing expansion card.
NOTE:
expansion card.
a. If you are removing a slot cover, insert a flat-bladed screwdriver into the slots on the rear of slot
cover (1) and rock the slot cover back and forth (2) to break it free from the chassis.
(Access panel on page
Before removing an installed expansion card, disconnect any cables that are attached to the
Computer major components on page
(Preparation for disassembly on page
23).
6.
20).
Expansion card 31