Table of Contents
Advertisement
Computer will not boot from hard drive.
Cause
Boot order is not correct.
Hard drive is damaged.
Computer seems to be locked up.
Cause
Program in use has stopped responding to commands.
Solving media card reader problems
Media card will not work in a digital camera after formatting it in Windows.
Cause
By default, Windows will format any media card with a capacity
greater than 32MB with the FAT32 format. Some digital cameras
use the FAT (FAT16 & FAT12) format and can not operate with a
FAT32 formatted card.
A write-protected or locked error occurs when attempting to write to the media card.
Cause
Media card is locked. Locking the media card is a safety feature
that prevents writing to and deleting from an SD/Memory
Stick/PRO card.
80
Chapter 6 Troubleshooting without diagnostics
Solution
Run the Computer Setup utility and change boot sequence in
Advanced > Boot Options.
Observe if the front panel Power LED is blinking RED and if any
beeps are heard. See
POST error messages on page 100
determine possible causes for the blinking red and beep codes.
See the Worldwide Limited Warranty for terms and conditions.
Solution
1.
Use the task manager to close programs that do not
respond.
2.
Attempt the normal Windows "Shut Down" procedure. If this
fails, press the power button for four or more seconds to
turn off the power. To restart the computer, press the power
button again.
Solution
Either format the media card in the digital camera or select FAT
file system to format the media card in a computer with Windows.
Solution
If using an SD card, make sure that the lock tab located on the
right of the SD card is not in the locked position. If using a Memory
Stick/PRO card, make sure that the lock tab located on the bottom
of the Memory Stick/PRO card is not in the locked position.
to
Hide quick links:
Advertisement
Table of Contents
