Commissioning; Maintenance - Siemens 7XV5450 0BA00 Operating Instructions Manual

4.5

Commissioning


Clip the signal converter on the top–hat rail according
EN 50022 with the help of clip-on mounting. Do not make any changes at the
device.

Check whether the operation data comply with the values on the rating plate.
Not change any DIP-switch at the device, before reading this manual.

Connect FO cable to FO receiver (R) and FO transmitter (T) with the help of ST
plugs. Be carefull when connecting the FO plugs and avoid any dust at the FO –
connections.

Connect to RS232 terminals and screw them for permanent use.

Connect the alarm relay terminals X7.

Connect auxiliary power to the terminals X2 (DC: L+ / AC: L1 and DC: L- / AC:
N).

The device is ready for use after switching on the auxiliary power. The green
LED `RUN´ lights up.
4.6

Maintenance

The signal converter requires no maintanance. For cleaning please use a dry and
free of fuzz rag. Put the caps onto the FO-interfaces to avoid dust pollution and
interference from sun light or any artifical light source.
When installing optical fibres the prescripted bending radius is to be observed.
7XV5450-0BA00
Note
Do not use any liquid agents or substances for
cleaning.
Mini-Star coupler
C53000-B1140-C595-1
Page 25 of 28