Operation - Team HAM MobileCom 1011 Manual

MICROPHONE

OPERATION

On/Off
1. To switch on the HAM MobileCom 1011, turn the volume control (13) clockwise, over the
contact barrier. An acoustic signal is emitted and the LCD lights up.
2. To switch off the radio, turn the volume control (13) counterclockwise over the contact barrier.
Volume
Turning the volume control (13) will adjust the volume level. The LCD will then display the
actual volume level (1-36).
TX Power
For the adjustment of the tx power use the power control (9). The maximum tx power of the se-
lected frequency band (AM / FM / SSB) is set by turning the power control clockwise all the
way to the end.
RF Gain
For the adjustment of the receiver sensitivity use the RF-Gain control (10). If received signals
are distorted due to immediate proximity to the transmitter, the receiver sensitiviy can be re-
duced with the RF Gain function.
SQUELCH
For the adjustment of the squelch level use the squelch control (11). During adjustment, the
symbol SQ and the actual level (1-36) are displayed.
SSB Clarifier
For fine tuning of the transmitter and receiver frequencies for USB / LSB, use the SSB Clari-
fier control (12).
Channel Selection
Use the rotary channel selector control (14) for channel selection.
Please note: for a manual entry of the frequency, push the rotary channel selector [PUSH]
(14). The fourth digit starts blinking. Set the value by turning the channel selector and push it
to confirm the entry and to proceed to the next digit. Continue repeating these steps until all
entries have been made.
22