Antenna Connection, Power Supply Connection; Fuse Exchange - Team HAM MobileCom 1011 Manual

antenna connection
Connect the antenna connector of the cable with the PL-jack (20), located on the rear of the
radio. Ensure a proper connection of the cable to the antenna base. Improper connections can
cause damages to the radio and a reduction of the operational range may be the result.
The antenna setup has to be adjusted to the radio. Otherwise, a part of the transmission power
is reflected at the antenna and is not radiated. A reduced range of operation could be the conse-
quence.
power supply connection
The voltage has to be 13.8 V DC with negative grounding. Ensure that the positive and (+, red)
and negative (-, black) polarity is correct, bevor you connect the radio.
The connection of the radio to the power supply, has to be set up by an authorized technician.
Connnect the power cable directly onto the batterie. Do not use a cigarette lighter adapter
because this kind of connectivity might not provide enough currenct for a proper operation of
the radio. Payspecial attention to the correct polarity, when connecting the cable onto the
batterie.
CAUTION
> Please ensure proper polarity
> Please check the fuse before first use of the radio. Missed or defect fuses need to be re
placed before operation of the radio.
fuse replacement
This radio requires a 15A/250V fuse. If the fuse blows, determine the cause, then correct the
problem. After the problem is resolved, replace the fuse. If newly installed fuses continue to
blow, disconnect the power cable and contact your authorized dealer or an authorized ser-
vicecenter.
1. Pull the two fuse cover in difference direction and open it.
2. Replace the broke fuse with good one, and close the fuse holder.
3. Be sure to use suggested fuse, or it might damage the radio.
19