Konica Minolta SRX-101A Service Manual page 48

5-4. Trouble Caused by the Film Processor
No. Trouble
1 The processed film
surface is coming out
grimy.
2 The film is coming out
damaged.
3 Uneven developer
(1)Poor solution
circulation
Cause
· The processing tank rollers · Clean the rollers.
are dirty.
· The processing solutions
are dirty.
· The wash water is dirty.
· The cleaning film mainte-
nance procedure is not
being properly carried out.
· The film holder in the feed
tray is dirty.
· Improperly set or damaged · Set the racks properly in place.
processing racks.
· Improperly set or damaged · Set the rack properly.
drying racks.
· There are pointed or edges · Repair the damaged area.
damaged areas in the feed · Replace the tray.
tray film holder.
· Damaged guides in the
processing tanks.
· Rollers have not been set
properly in their racks.
· Improper roller rotation.
· Improperly set drive shaft.
· Loose or damaged roller
pressure springs
· Damaged gears.
· Damaged or worn
developer circulation pump
(P1).
· Damaged circulation pipe
lines.
· Blocked circulation pipe
lines.
TROUBLE SHOOTING
Response
· Replace the processing solutions.
· Clean the processing tanks.
· Check the wash water level.
· Replace the electromagnetic
wash water supply valve if dam-
aged.
· Clean the feed tray film
holder.
· Repair the damaged or replaced
the racks.
· Repair the damage or replace
the rack.
· Clean the film holder.
· Repair the damaged guide.
· Set the rollers properly.
· Replace any damaged drive shaft
supports.
· Check if the drive shaft supports
are set properly.
· Set the springs properly in place.
· Replace damaged springs.
· Replace damaged gears.
· Replace the pump.
· Repair the pipe line.
· Clean the pipe line.
Advice To Customer
· Remind about checking
and maintenance tasks.
· Remind about the cleaning
film procedures.
· Show the proper method
for setting the racks using
the guide arrows.
· Show the proper method
for setting the rollers.
SERVICE MANUAL 43