Siemens SIMATIC Box PC 820 Manual page 165

CD-ROM Front
1 Access display
2 Drawer
3 Eject button
4 Emergency eject
Emergency Eject
The procedure described below can be used to remove a disc from the CD-ROM
reader if the Open/Close button is disabled by software or a power failure occurs.
In this case, the CD tray cannot be opened automatically.
1. Turn off the power to the CD-ROM reader (switch off your device if necessary).
2. Insert a steel rod or a stiff paper clip (with a maximum diameter of 1.3 mm and
a minimum length of 55 mm) into the emergency eject hole at the front of the
drive and push lightly. The CD tray is ejected by about 10 mm. Pull it all the way
open by hand and lift the disc out carefully.
Figure 9-1 Emergency removal
Caution
!
Risk of data loss and damage to the drive!
CD-ROM drives are sensitive to vibrations and shock. Any vibrations occuring during
operation can lead to damage to the drive or CD.
Siemens Distributor
Box PC 820 / PC FI45 V2, Manual
A5E00051531-03
2 1
CD-ROM Drive
3 4
at least 55mm (2.17") long
9-3