Advertisement
Technical Solutions
Bellman Visit System Information
Function
General
The BE1465 Bellman Visit 868 Guard Receiver is primarily intended as a central unit in a Smoke Alarm
System but is also a receiver in the Bellman Visit 868 System. The product is intended for indoor use and
attracts the attention of the user with a flashing light, light signal and vibration via the Bed Shaker (19). The
Guard Receiver monitors the radio link to all BE1480 Bellman Visit 868 Smoke Alarms which are registered
to the Guard Receiver and gives a warning if the smoke alarm does not respond correctly.
At the same time the Guard Receiver works together with the Bellman Visit 868 System. In other words you
can use your existing Bellman Visit 868 products together with a Guard Receiver.
It is activated via radio signals from any transmitter within the Bellman Visit 868 System or via an external
trigger input (9).
A short press on the Test Button (2) activates BE1465 so that it repeats its last indication.
Radio key
On delivery all Bellman Visit 868 units are tuned to the same Radio Key. If you have a neighbour with a
similar system, you can change to different Radio Keys so that you do not affect each other's systems.
If the Guard Receiver has to work with an existing Bellman Visit 868 System, it must be set to the same Radio
Key as this system.
1. Check the system's Radio Key by looking at setting of the Radio Key Switch on the
existing transmitters,
2. Set the Radio Key Switch on the Guard Receiver
same Radio Key as the other units.
Please note! It is NOT possible to set the Radio Key via the Test Button as can be done with the other
receivers.
3. Press the test button on a Bellman Visit 868 transmitter and the Guard Receiver
will start to flash and emit light signals and the Bed Shaker will vibrate.
For further information see Function/Radio key.
If you use the Radio Key Switch
other units in your Bellman Visit 868 System to the same Radio Key. Refer to the user manual for the relevant
unit for more information.
all Bellman Visit 868 products within the same
system must be tuned to the same Radio Key in
order to operate as a group.
External trigger
It is possible to connect the vibrator output on several of Bellman & Symfon AB's products or other
equipment that forms a contact or voltage to an external trigger (9) for activation. See Technical Information
in the Appendix for further details.
During activation via the External Trigger (9), further activations can be disregarded for about 45 seconds if
the Snooze Button (2) is pressed when indications are active.
(17) to change the Radio Key on this receiver, you must also change all
Please note:
Be1465
(17) and on the Smoke Alarm
Page 95
(21) to the
Hide quick links:
Advertisement
