Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Bellman & Symfon BE9024
Summary of Contents for Bellman & Symfon BE9024
-
Page 2: Installation
Overview Installation On/Off and settings LED lights Ext trig input Microphone 1 Remove the battery pull tab to start the baby monitor. 2 Place the baby monitor on the nightstand or hang it on the wall with the screw and plug. The recommended distance is 0.5-2 m, out of reach from the child. Turn off: Press and hold both buttons for 3 s Switch on: Press and hold both buttons for 1 s Contact mat... - Page 3 Testing Settings 1 Stand by the child’s bed and make a noise. The buttons for sensitivity and delay are located on the baby monitor’s left side. When you press the button, the LED shows the current setting. Then press repeatedly to 2 The Visit receiver lights up a pacifier symbol and indicates with sound, lights adjust the setting.
-
Page 4: Technical Information
Not reusable. Safety and regulations For information on safety and regulations, see the Installer’s Guide. BE9024 Contact mat (sold separately) Service and support For information on service and support, see the Installer’s Guide. -
Page 5: Installer's Guide
Installer’s Guide Introduction Installation Testing Settings Default indication and signals Customizing the signal Trouble shooting Technical information... - Page 6 The baby monitor can be activated by either: The test buttons (press simultaneously) The built-in microphone The BE9024 Contact mat accessory (connected to the Ext trig input) Settings The baby monitor allows you to adjust the sensitivity and delay and you can set Turn off: Press and hold both buttons for 3 s a unique signal for each child, so you know who needs your attention.
- Page 7 2 Place the baby monitor on the nightstand or hang it on the wall with the tell you when your child steps on it. screw and plug. The recommended distance is 0.5 - 2 m, out of reach from the child. BE9024 Contact mat (sold separately)
-
Page 8: Advanced Testing
Testing Advanced testing 1 Stand by the child’s bed and make a noise. Testing the baby monitor is easy. First, make sure that the baby monitor is installed properly. For instructions, read the section Installation. 2 The Visit receiver lights up a pacifier symbol and indicates with sound, lights or vibrations (depending on the receiver). - Page 9 Settings Default indication and signal Transmitter indication The buttons for sensitivity and delay are located on the baby monitor’s left When the baby monitor is activated, the LED indicator lights up in green. This side. When you press the button, the LED shows the current setting. Then press means that the batteries are in good condition.
- Page 10 Customizing the signal Changing the radio key The baby monitor controls the signal pattern on the If you install multiple systems, you can set a receiver. By moving a signal switch up=on you unique radio key for each system to avoid can set a unique signal for each baby.
- Page 11 Signal output for 868 MHz and 315 MHz Signal output for 433 MHz Test button 1or 2 Test button 1or 2 Dip switch Output External trigger Dip switch Output External trigger Internal Mic Internal Mic Light Orange light Green light Light Orange light Green light...
-
Page 12: Troubleshooting
Trouble shooting Try this Try this Two orange lights • Change the batteries. Only use 1.5 V AA (LR6) lithium The baby monitor is • Reduce the sensitivity or move the baby monitor appear every 10s or alkaline batteries. activated too easily further away from the crib, see Settings. - Page 13 Technical information accept any interference, including interference that may cause unde- Hereby, Bellman & Symfon de- Use and disposal of batteries sired operation of the device. clares that this Baby monitor is Replace only with the same or equi- Power supply Battery power: 2 x 1.5 V AA (LR6) lithium or alkaline batteries.
- Page 14 DESIGN FOR EARS ™ bellman.com...
Need help?
Do you have a question about the BE9024 and is the answer not in the manual?
Questions and answers