Table of Contents
Advertisement
3
Installation and Configuration
3.1 Mounting to rack
Take out the supplied 2 mounting
brackets (for 19-inch rack) and 8
screws (for fixing the main unit and
the mounting bracket), and fix the
brackets to the main unit by
tightening screws into 4 holes located
at the sides. Then, mount this
Switching Hub firmly to the rack
using the supplied 4 screws (for
19-inch rack) or screws furnished at
the rack.
3.2 Configuration of IP address (Basic)
(1) Connect this Switching Hub and PC with a RJ45–DSub 9-pin console cable and
start up the terminal emulator (ZEQUO assist Plus, etc.).
(2) Pressing Enter key 3 times opens Login screen. Enter Login name and Password
(the default is "manager" for both). (Screen 1)
(3) Main Menu is displayed. (Screen 2)
Press "B" to select [B]asic Switch Configuration. The next hierarchical menu is
displayed. (Screen 3)
(4) Press "I" to select System [I]P Configuration. The screen to enter some addresses
is displayed. (Screen 4)
(5) Press "I" to set an IP Address, press "M" to set a Subnet Mask, or press "G" to set
a Default Gateway. Then enter the specified address. (Screen 4)
(6) After completing the settings, select [Q]uit to previous menu twice to return to
Main Menu (Screen 2). Here, select Save Configuration to [F]lash (Screen 5)
and the command prompt changes to "Save current configuration? (Y/N)." Press
"Y" to save the settings.
(7) From terminals connected to network, confirm that the settings are reflected
correctly by executing PING test for entered address.
16
Advertisement
Table of Contents
