Table of Contents
Advertisement
2.2 Installing the Industrial Serial Server
This section describes how to install your Industrial Serial Server and make connections to the Industrial Serial Server. Please
read the following section and perform the procedure in the order being presented. To install your Industrial Serial Server on a
desktop or rack, simply complete the following steps.
2.2.1 Installation Steps
1.
Unpack the Industrial Serial Server
Check if the DIN-rail bracket is screwed on the Industrial Serial Server or
2.
the Industrial Serial Server, please refer to DIN-rail Mounting section for DIN-rail installation. If users want to
wall-mount the Industrial Serial Server, please refer to the Wall Mount Plate Mounting section for wall-mount plate
installation.
3.
To hang the Industrial Serial Server on the DIN-rail track or wall.
4.
Power on the Industrial Serial
about how to wire the power. The power LED on the Industrial Serial Server will light up. Please refer to the LED
Indicators section for indication of LED lights.
5.
Prepare the twisted-pair, straight-through Category 5 cable for Ethernet
6.
Insert one side of RJ45 cable (category 5) into the Industrial Serial Server Ethernet port
side to the network device's Ethernet port (RJ45 port), e.g., Switch PC or Server. The UTP port (RJ45) LED on the
Industrial Serial Server will light up when the cable is connected with the network device. Please refer to the LED
Indicators section for LED light indication.
Make sure that the connected network devices support MDI/MDI-X. If it does not support,
use the crossover Category 5 cable.
7.
When all connections are set and all LED lights show normal, the installation is completed.
User's Manual of IGS-2x00T Serial Device Server Series
Server. Please refer to the Wiring the Power Inputs section for knowing the information
20
not. If the DIN-rail bracket is not screwed on
connection.
(RJ45 port) while the other
Advertisement
Table of Contents
