Console; Fault Alarm - Planet Networking & Communication Serial Device Server Series User Manual

4.2.5 Console

This page is to configure management methods for web and remote console. The screen in
The page includes the following fields:
Object
Web Console
•
• Remote Console
• Current Time

4.2.6 Fault Alarm

This page provides configuration for fault alarm. The screen in
The page includes the following fields:
Object
• Buzzer
• Record
• Event
• Power Alarm
• Monitoring of DCD Change
• Monitoring of DSR Change
User's Manual of IGS-2x00T Serial Device Server Series
Figure 4-2-5: Console Setup Page Screenshot
Description
To enable or disable access to the web console. The default is Enable.
To enable or disable access to the remote console. The default is Enable.
To check whether the reset button is working or not. The default is No.
Figure 4-2-6: Fault Alarm Control Page Screenshot
Description
To check whether Buzzer is enabled on this switch.
To check whether Record is sending System log or SNMP Trap or both.
To check whether Power, Connection, etc. are working or not.
PWR1 or PWR2 or both have faulted..
Monitor which Port or all for DCD signal that has changed.
Monitor which Port or all for DSR signal that has changed.
37
Figure 4-2-6 appears.
Figure 4-2-5 appears.