Protection Against Dangerous Movements - Bosch Rexroth Indramat ECODRIVE DKC02.1 Series Project Planning Manual

2-4
Safety instructions for electrical drives
2.4

Protection against dangerous movements

LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Dangerous movements can be caused if the connected motors are not
controlled correctly.
There are various causes of dangerous movements:
• faulty wiring or cable connections
• operating the components improperly
• defective measured value transmitters and primary detectors
• defective components
• errors in the software
These errors can occur just after the equipment has been switched on or
after an indefinite period of time.
The monitors in the drive components virtually exclude failure in the con-
nected drives. However, personnel safety requires that additional meas-
ures be taken to ensure correct operation. Faulty drive motions which are
influenced by the type of control and the operating status cannot be en-
tirely excluded until the installed monitors take effect.
ECODRIVE DKC02.1 Drive Controller
DOK-ECODRV-DKC02.1****-PRJ2-EN-P