Key Automation ALT3KF Series Instructions And Warnings For Installation And Use page 22

8 - TESTING AND COMMISSIONING THE AUTOMATION SYSTEM
The system must be tested by a qualified technician who must carry
out the tests required by the applicable standard according to the
existing risks, ensuring compliance with the standard provisions, in
8.1 - Testing
All system components must be tested following the procedures de-
scribed in their respective operator's manuals;
ensure that the recommendations in Chapter 1 - Safety Warnings -
have been complied with;
Check that the bar can move freely once the automation system is
released and that it remains stationary and balanced if left at a 45°
angle
8.2 - Commissioning
Once all (and not just some) of the system devices have passed the
testing procedure, the system can be commissioned;
The system's technical dossier must be produced and kept for 10
years. It must contain the electrical wiring diagram, a drawing or
photograph of the system, the analysis of the risks and the solutions
adopted to deal with them, the manufacturer's declaration of con-
formity for all connected devices, the operator's manual for every
device and the system maintenance plan;
Fix to the barrier lift body a data plate indicating the automation data,
the name of the person in charge of commissioning, the serial num-
ber and the year of construction, and the CE mark
particular the EN12445 standard which specifies the test methods to
be applied to the motorized doors
Check the correct operation of all the connected devices (photocells,
sensitive edges, emergency buttons, others) by carrying out barrier
opening, closing and stopping tests via the connected control devi-
ces (transmitters, buttons, selector switches)
Perform the impact measurements as required by the EN12445
standard, adjusting the control unit's speed, motor force and dece-
leration functions if the measurements do not give the required re-
sults, until the correct setting is obtained.
Also fit a sign specifying the procedure for releasing the system by
hand;
Draw up the declaration of conformity, the instructions and precau-
tions for use for the end user and the system maintenance plan and
consign them to the end user;
Ensure that the user has fully understood how to operate the system
in automatic, manual and emergency modes;
The end user must also be informed in writing about any risks and
hazards still present.
EN
51