Related Manuals for IEI Technology ECA-200
Summary of Contents for IEI Technology ECA-200
- Page 1 ECA-200 Industrial Chassis for microATX SBC Quick Installation Guide Version 1.00 PACKING LIST 1 x ECA-200 chassis 1 x SATA cable 1 x Power cord 2 x Wall mount brackets 1 x Holder bracket 1 x Slide track 1 x Power housing...
-
Page 2: Safety Instructions
SAFETY INSTRUCTIONS Warning! Read this installation guide before connecting the system to the power source. Warning! To prevent the device from overheating, do not operate it in an area that exceeds the maximum operating temperature described in the user manual came with the SBC. Warning! Ultimate disposal of this product should be handled according to all national laws and regulations. -
Page 3: Power Supply Options
IMB-Q770-R10 microATX IMB-H810-i2-R10 microATX IMB-H610A-R10 microATX IMB-H110-R10 microATX POWER SUPPLY OPTIONS Type Model No. Watt ACE-A615A-RS-R11 150W ACE-A618B-RS-R10 180W ACE-A622A-RS-R11 220W ACE-A627A-RS-R11 270W ACE-A630B-RS-R10 300W DIMENSION DRAWING The dimensions of ECA-200 are shown below (Unit: mm). -
Page 4: Remove Chassis Cover
INSTALLATION STEPS To install the ECA-200 chassis, follow the steps below: Step 1: Remove chassis cover. Step 2: Install motherboard. Step 3: Install power supply unit. Step 4: Install system fan. Step 5: Install hard disk drive. Step 6: Reinstall top cover. -
Page 5: Power Supply Unit Installation
Step 2: Install the I.O shielding. Push the I.O shielding in the chassis. POWER SUPPLY UNIT INSTALLATION Step 1: Install the power supply bracket to the power supply. Secure the power supply bracket to the power supply with the screws as figure shown below. -
Page 6: System Fan Installation
Step 2: Install the power supply to the chassis. Secure the power supply to the chassis with the screws as figure shown below. SYSTEM FAN INSTALLATION Step 1: Install the system fan. Place the system fan inside the chassis and align the retention screws holes on the system fan with the retention screw holes on the chassis. -
Page 7: Hard Disk Drive Installation
To correctly connect these cables, please refer to the user manual that came with the motherboard. ----------------------------------------------------------------------------------------------------------------- FRONT PANEL CABLE CONNECTION The following buttons and LEDs are on the front panel of the ECA-200 chassis. 1 x Power switch ... -
Page 8: Reinstall Top Cover
Step 1: Install the wall mount brackets. Align the four retention screw holes in the wall-mount brackets with the retention screw holes on the side of the chassis. ----------------------------------------------------------------------------------------------------------------- NOTE: There are two methods of mounting the ECA-200. The mounting methods are shown below. -----------------------------------------------------------------------------------------------------------------... -
Page 9: Front Handle Installation
FRONT HANDLE INSTALLATION Step 1: Install the front handle. Align the retention screw holes in the handles with the retention screw holes on the side of the chassis. Install each handle to the chassis with four retention screws. - Page 11 Headquarters America China 威強電工業電腦股份有限公司 威强电工业电脑 IEI Integration (Shanghai) Corp. IEI Technology USA Corp. 上海市闵行莘庄工业区申富路 515 号 IEI Integration Corp. 138 University Parkway, Pomona, 22161 新北市汐止區中興路 29 號 CA 91768, USA No.