POWER SUPPLY SPECIFICATIONS Drive Bays One 3.5” HDD System Cooling fan One 6cm fan The EBC-3000 embedded chassis is shipped with a power supply. The specifications for each option are listed below. I/O Ports Depends on SBC Indicators Power, HDD LED...
20-pin ATX, 4-pin 12 V, FDD and 3 x HDD Connector Dimensions 150 x 81.5 x 40.5 (mm) Table 4: ACE-A618A-RS Specifications PACKING LIST EBC-3000-R10/ACE-A627A or EBC-3000-R10/ACE-A618A Quick Installation Guide Power cord SATA cable for slim type ODD Screw set Wall mount kit...
INSTALLATION STEPS INSTALL I/O BRACKET To install the EBC-3000 chassis, the following installation steps must be Note: I/O brackets differ in appearance depending on the SBC model to be completed: installed in the EBC-3000. Remove Chassis Cover Install I/O Bracket...
Figure 10: HDD/ODD Bracket Retention Screws FRONT PANEL CABLE CONNECTIONS The following buttons and LEDs are on the front panel of the EBC-3000 chassis. Figure 8: HDD Retention Screws 1 x Power LED...
Figure 12: Wall-mounting the EBC-3000 EBC-3000 MAINTANENCE The following EBC-3000 components may be replaced if they fail: Power Supply Replacement System Fan Replacement Figure 11: Wall-mounting Bracket and Retention Screw...
(Figure 15). Figure 15: System Fan Retention Screws Step 4: Install the new system fan with the four previously removed retention screws. Step 5: Reconnect the system fan cable connector. EBC-3000 IEI Technology Corp. Page 7...