Connecting The Ac Adapter - Epson OmniLink TM-T70-i Technical Reference Manual

Connecting the AC Adapter

Use AC adapter,RA as the power supply unit for this product.
 Be sure to use the included AC adapter as the power supply unit.
 Should a fault ever occur in the included AC adapter, immediately turn off the power
WARNING
 Be sure to unplug the power supply unit's cable from the wall socket whenever
 Make sure the wall socket power supply satisfies the rated voltage requirements of
When installing the DC 5 V cable through the cable exits on the back, fix the cables with the
cable band to prevent the cables from coming off. (See
page
Make sure that the power is turned off, and connect the AC adapter,RA in the following steps.
1
Push the DC connectors of the AC adapter all the way into the DC-In
connectors (5V and 24V) of the product.
DC-in(24V)
2
Push the connector of the power code all the way into the AC inlet of the
AC adapter.
3
Push the power plug all the way into the grounded outlet.
4
Place the AC adapter with the label facing down.
Using a nonstandard power supply can result in electric shock and fire.
to the product and unplug the power supply cable from the wall socket.
connecting or disconnecting the power supply unit to the product.
Failure to do so may result in damage to the power supply unit or the product.
the power supply unit. Never insert the power supply cable plug into a socket that
does not meet the rated voltage requirements of the power supply unit.
Doing so may result in damage to both the power supply and the product.
42.)
DC-in(5V)
Chapter 2
"Attaching the Connector Cover" on
Setup
2
41