Attaching The Connector Cover - Epson OmniLink TM-T70-i Technical Reference Manual

Attaching the Connector Cover

Follow the steps below to attach the connector cover to protect cables.
1
Make sure the printer is turned off, connect all the cables.
2
Position the two hooks on both sides of the connector cover so that they
hook the printer case.
42
 The connector cover has a cable exit on both sides. You can also make an exit on the
back of the connector cover by removing the tab by breaking it off with your fingers. If
any protruding plastic remains after removing the tab, also remove it so that the edge
is smooth and does not damage the cables.
 Once you remove the tab, you cannot replace it.
Tab