Advertisement
Rear Panel
Antenna Connectors: The reverse sMa connectors allow easy connection to
external antennas.
Reset button: This can be used to reset the router or to restore the factory default
settings. Press the button (using a pencil tip can help) for less than five seconds
to re-boot the router and save any configurations that have been set up.
If problems persist after a simple re-boot — or if you've forgotten your password —
hold the button in for longer than five seconds to reset the router to its factory
default settings. NOTE: The factory default settings will replace any others that
have been configured.
Power outlet: The included 12 V dC power adapter is connected here.
WPS button: Wi-Fi Protected setup (WPs) is the simplest way to build a connection
between wireless network clients and this router. Press this button and enable the
WPs function of the wireless clients; the router and clients will automatically
configure the security key and connect directly. noTe: The router will wait for
WPs requests from wireless clients for 2 minutes after the WPs button is pressed.
LAN ports: The four local area network (lan) ports are for connections to PCs,
lans, printers, servers, hubs and so forth.
ADSL: The included RJ- 1 1 phone line connects this to an adsl/phone network.
Connections
1. From the adsl port, connect the router to your adsl network using the RJ- 1 1
telephone cable provided.
2. From any of the lan ports, connect the router to your PC, hub, switch or
other component using the ethernet Cat5 RJ-45 cable provided.
3. Connect the router's power outlet to a power source using the power adapter
provided. NOTE: Use only the power adapter included with this device.
4. Check that the green adsl led is on, indicating a successful connection. If
the adsl led is blinking — indicating that no connection has been made —
contact your Internet service provider.
5
Advertisement
