Alarms - IPC CT5 LAVAMATIC Operator's Manual

Squeegee not cleaning or vacuum weak.
Battery not giving expected operational
endurance.
Brush motor thermal overload.
Brush motor overcurrent/short
circuit.
Detergent pump overcurrent/
short circuit.
Suction motor overcurrent/short
circuit.
Excess battery voltage.
[B-C] Lip of rubber blades in contact
with the floor has become worn.
[B-C] Float controlled shut-off has been
tripped (dirty water tank full).
[B-C] Blockage in squeegee suction
hose.
[B-C] Suction hose either not connected
to squeegee, or damaged.
[B-C] Diverter valve dirty.
[B] Battery charger not working.

ALARMS

Red Led alight on brush control button, 1
slow blink
Red Led alight on brush control button, 1
fast blink.
Red Led alight on brush control button, 2
fast blinks.
Red Led alight on suction control button, 1
fast blink.
Green battery charge Led blinking.
EN
[B-C] Replace squeegee blade.
[B-C] Empty out dirty water tank.
[B-C] Remove blockage.
[B-C] Connect or repair suction hose.
[B-C] Clean diverter valve.
[B] Replace battery charger.
Switch off all functions of the machine.
Remove the dirty water tank to let more air into
the motor housing.
Wait a few minutes, then restart the machine
If the problem persists, contact customer
service.
Switch off all functions of the machine.
Restart the machine.
If the alarm appears again, make certain that
the brush is not being used on a particularly
rough floor.
If the problem persists, contact customer
service.
Switch off all functions of the machine.
Restart the machine.
If the problem persists, contact customer
service.
Switch off all functions of the machine.
Restart the machine.
If the problem persists, contact customer
service.
Check the integrity, operation and use of the
battery charger supplied with the machine.
26