Installation; Initial Preparation - Chappee EDENA CLASSIC E 35 Installation And Servicing Instructions

7.0 INSTALLATION

7.1 Initial Preparation

The gas supply, gas type and pressure must be
checked for suitability before connection.
1. Ensure that the floor or base on to which the boiler is
to be fitted is clean and free from debris.
2. Install any pipework that will be behind the boiler, and
any appropriate flue components.
3. Manoeuvre the boiler into position, seeking assis
tance as necessary. Check the clearancesas shown
in Section 6.1.
4. Connect the gas supply pipe and the system flow and
return connections to the boiler.
5. Connect the flue systemt. Any flue pipe must be at
least the same diameter as the connection on the
boiler draught diverter.
7.2 Making the Electrical
1. Undo the two securing screws from the rear of the top
panel. Remove the panel
2. Swivel the two retaining plates through 90°. Lift the
control box slightly and allow it to hinge forwards.
Undo the two retaining screws and remove the cover
panel.
3. The input wiring to the boiler and the pump feed from
the boiler should be routed through the grommet/
clamps in the control box rear panel.
4. Remove the clamps from the panel and slit the
grommets with a suitable knife or blade.
5. Determine the length of the wiring and secure in the
clamps.
6. Connect live, neutral, earth, and switched live to L, N,
& SL of the terminal strip. The pump live, neutral and
earth should be connected to PL, PN &
terminal strip.
T H L
Réf. : CH - 1254 - I - 0 - EN
of the
N L
Terminal strip
T
Safety Thermostat
Magnets
Front Panel
Cover Panel
Burner
Control
Connection
Earth Point
H L N L
10
Top Panel
Boiler draught
Diverter connection
Cable Clamps
Grommet
Temperature Control Thermostat
Securing
Screws
Flow Connection
Gas Inlet
Return Connection