Table of Contents
Advertisement
Hardware Installation Manual
3.
Connect your analog equipment to the Patch Panel, by plugging in each RJ-11
connector into the RJ-11 sockets on the Patch Panel's front panel:
Figure 5-8: Connecting Analog Equipment to FXS Patch Panel
5.3.2
Connecting FXS Interfaces Directly to MDF
If you are using your own third-party MDF, follow the instructions below for connecting the
FXS analog equipment to the device directly through the MDF.
Warning:
terminated on a metal-hooded 50-pin Telco connector.
To connect FXS interfaces directly to the MDF:
1.
Wire the 50-pin Telco connectors according to the pinouts in
2.
Connect the wire-pairs at the other end of the cable to a male 50-pin Telco connector
(not supplied).
3.
Insert and fasten the male connector to the female 50-pin Telco connector on the
device's rear panel (labeled ANALOG FXS LINES 1-24).
4.
Attach each pair of wires from a 25-pair Octopus cable (not supplied) to its
corresponding socket on the MDF.
MediaPack Analog Gateways
To reduce noise interference, use a twisted pair Octopus cable that is
27
5. Cabling the Device
Table
5-1.
MP-124
Advertisement
Table of Contents
