Steps
1. Adhere the camera to the display cable (tape) and connect the camera cable to the camera and turn it over.
2. Using the alignment post, turn the camera over and adhere to the display back-cover.
3. Adhere the tape that secures the camera to the display back-cover.
Next steps
1. Install the
display
panel.
2. Install the
display
bezel.
3. Install the
display
assembly.
4. Install the
WLAN
card.
5. Install the battery.
6. Install the
base
cover.
7. Follow the procedure in
Display back-cover
Removing the display back-cover
Prerequisites
NOTE:
This procedure is not applicable to computers shipped with a WWAN configuration.
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
WLAN
card.
5. Remove the
display
assembly.
6. Remove the
display
bezel.
7. Remove the
display
hinges.
8. Remove
thedisplay
panel.
9. Remove the
display
cable.
58
Removing and installing components
After working inside your
computer.
Before working inside your
computer.