About this task
The following image indicates the location of display hinges and provides a visual representation of the installation procedure.
Steps
1. Align the screw holes on the hinges with the screw holes on the display back-cover.
2. Replace the two (M2x2) screws that secure the display hinges to the display back-cover.
3. Replace the four (M2.5x2.5) screws to secure the display hinges to the display back-cover.
Next steps
1. Install the
display
bezel.
2. Install the
display
assembly.
3. Install the
WLAN
card.
4. Install the battery.
5. Install the
base
cover.
6. Follow the procedure in
Camera
Removing the camera
Prerequisites
NOTE:
This procedure is not applicable to computers shipped with a WWAN configuration.
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
WLAN
card.
5. Remove the
display
assembly.
6. Remove the
display
bezel.
7. Remove the
display
panel.
56
Removing and installing components
After working inside your
computer.
Before working inside your
computer.