: Slide the cover (1) over the spark
plug boot (2) and align
: Ensure that the torsion spring
(arrow) is located in the recess
– Reassemble remaining parts in
reverse order
7.4.1
Ignition lead
– Remove control unit, b 7.3
3
1
2
: Push the grommet (1) off the
control unit (2)
: Unscrew the ignition lead (3)
from the control unit (2)
– Check the control unit and
ignition lead, replace if necessary
68
– Examine the spark plug boot and
replace it if necessary, b 7.4
1
Installation
2
: Use a pointed tool to pierce the
center of the end of the new
ignition lead, which is to be
twisted into the control unit.
– Before twisting in the ignition
lead, fill the coil tower with STIHL
multi-purpose grease, b 13
2
1
: Push grommet (1) onto ignition
lead
: Twist ignition lead (2) completely
into the control unit
: Push on the grommet (1)
– Install control unit, b 7.3
– Reassemble remaining parts in
reverse order
7.5
Flywheel
– Remove fan cover, b 6.3
– Block piston, b 5.1
1
: Unscrew the flywheel nut (1)
1
2
: Push the spacer (1)
4238 894 1100 onto the screws
of the puller (2) 5910 890 4504
so that the larger diameters of the
holes face the puller
TS 500i