With the Z-Wave® controller in "adding" mode, press and
•
hold the top or bottom of the paddle for 3 seconds. The
controller will verify the add ition and will assign a node
ID to the switch.
With the Z-Wave controller in "removing" mode, press
•
and hold the top or bottom of the paddle for 3 seconds.
The controller will verify the removal, then will remove
the switch from the network. When removed from the
network, the LED will blink whenever the switch is
turned on.
If the primary controller is missing or inoperable, you
•
can reset the switch to its factory default settings by
pressing and holding the top or bottom paddle for 10
seconds.
Note: After a power failure, the switch will be turned off.
ADVANCED OPERATION
Configuration
The following Advance d Operation parameters require that you
have an advance d controller. Basic remotes do not have this
capability.
Parameter No.
Size
1
1 Byte
Descriptions
Synchronization of load
power and LED indicator
11
Valid Value
0: Power on, LED off
1: Power on, LED on
Default Value
Default=0