Connection And Operation - Monoprice MD-415ARC Instruction Manual

Connection
Step 1: Connect the HDMI cables from the HD sources devices to the input ports of the Switcher.
Step 2: Connect the HDMI cable from your HDTV (or projector) to the output port of the Switcher.
Step 3: Connect the DC 5V/2A power adaptor to the HDMI Switcher.
Step 4: After you finish the connection, the power indication LED (red), ARC indication LED (blue),
and port 1 input indication LED (green) will be lighted on.
Step 5: Initiate the CEC communication:
(1) Turn on the connected TV, Switch box, and all connected source devices.
(2) Select the source devices one by one, and make sure all source devices are working correctly.
(Audio and video correctly show on TV with no interruption or noise.)
(3) Follow the operational instruction below, and try all the operation function include CEC control
function (Routing Change, One Touch play, Standby.)
(4) If any function can not work, please restart the switcher and perform Step 5 again.
Note:
1. Initiate the CEC communication can make sure the switcher collect the correct EDID
information from source device and display device. Incorrect EDID information may cause
failure of CEC function. (Due to varied design of CEC device, some CEC devices will
automatically initiate the CEC communication with the switcher.)
2. The following conditions are recommended to initiate or re-initiate the CEC communication:
 When you first use the HDMI Switcher with your CEC enabled device.
 When you disconnect or change the cable connection routing of the connected HDMI
source devices.
 When you connect the output of switch box to another TV set.
Please check Step 5 in the connection instruction.
3. The CEC is working under standby mode for all connected CEC supported devices only.
Please make sure the power of all CEC supported devices are plugged in and under standby
mode.
4. The CEC feature only works with CEC supported devices.
5. Consumer Electronics Control (CEC) is also known as in following terms by their respective
Brand Name. Philips (EasyLink), Sony (BRAVIA Theatre Sync), Samsung (Anynet+), LG
(Simplink), Sharp (Aquos Link), Panasonic (HDAVI Control, EZ-Sync, and VIERA Link),
Pioneer (Kuro Link), Toshiba (CE-Link and Regza Link), Onkyo (RIHD, Remote Interactive
over HDMI), Mitsubishi (NetCommand). Each brand may have its extend CEC features.
6. Under standby mode, the HDMI switcher will memorize the latest input port. At your next use,
the HDMI switcher will detect and connect the latest input port first.
7. To reset the switcher, please unplug the power adaptor, or unplug the power cord from DC jack
for a short while; and then plug it back.
8 . HDMI 3D video format:
Frame packing
1920x1080p@23.98/24Hz
1280x720p@59.94/60Hz
1280x720p@50Hz
CONNECTION & OPERATION
Side-by-Side (Half)
1920x1080i@59.94/60Hz
1920x1080i@50Hz
3
Top-and-Bottom
1920x1080p@23.98/24Hz
1280x720p@59.94/60Hz
1280x720p@50Hz