NEC N8551-28F Instruction Manual page 30

11
Restart the system.
Important
When using Windows NT backup, do not install any other backup software. If any other backup
software is installed, make sure you uninstall it. Further, when using backup software other than
Windows NT backup, make sure you delete "Sony AIT Tape Drive (NT 4.0)".
Hint
The tape device driver installed after restarting the system is enabled.
For Windows 2000 Users
1
Click the [Start] button, then point to [Settings] and click [Control Panel]. Then click [System].
The [System Properties] dialog box appears.
2
Click the [Hardware] tab, then click the [Device Manager] button.
The [Device Manager] dialog box appears.
3
Confirm that [SONY SDX-500C SCSI Sequential Device] is displayed under [Other devices],
and double click [SONY SDX-500C SCSI Sequential Device].
The [SONY SDX-500C SCSI Sequential Device Properties] dialog box is displayed.
4
Click the [Driver] tab, and click the [Update Driver] button.
The [Upgrade Device Driver Wizard] appears.
5
Click the [Next] button.
The [Install Hardware Device Drivers] screen appears.
6
Select [Search for a suitable driver for my device (recommended)], and click the [Next] button.
The [Locate Driver Files] screen appears.
Insert the floppy disk provided.
7
Place a checkmark in the [Floppy disk drives] checkbox, and click the [Next] button.
The basic processing unit starts searching for driver files.
12 Built-in AIT