Ejecting The Ait Data Cartridge - NEC N8551-28F Instruction Manual

Ejecting the AIT data cartridge

Check that the BUSY LED goes off.
Then, press the EJECT button. The
Built-In AIT starts rewinding the tape
(this may take a few minutes).
When the tape is completely rewound,
the data cartridge is automatically
ejected from the Built-In AIT.
Remove the data cartridge from the slot.
Important
• When the BUSY LED lights or is blinking, do not turn off the basic processing unit. This may
cause a malfunction or damage data.
• To avoid malfunction, do not transport this unit with the data cartridge installed.
Built-in AIT 15