Table of Contents
Advertisement
Connection with a rubber hose
Make the connection to the gas mains
using a rubber hose whose specifications
comply with current standards (verify that
the reference standard is stamped on the
hose).
Carefully screw the connector 3 to the gas
connector 1 of the appliance, placing the
seal 2 between them. Push the rubber
hose 5 onto the hose connector 3 and
secure it with the clamp 4 – this must comply
with applicable regulations.
56
Installation
The hose connector 6 can also be screwed
to the hose connector 7, depending on the
diameter of the gas hose used. After
tightening the hose connectors, push the
gas hose 5 onto the hose connector 6 or
6+7 and secure it with the clamp 4 – this
must comply with applicable regulations.
Connection using a rubber hose
complying with current standards is
only permitted if the hose can be
inspected along its entire length.
The inside diameter of the hose
must be 8 mm for LPG and 13 mm
for Natural gas and Town gas.
Advertisement
Table of Contents
