Location Of The Data Link Connector (Dlc); Obd Ii Readiness Monitors - Launch Creader 5001 User Manual

Hide thumbs Also See for Creader 5001:
Table of Contents

Advertisement

LAUNCH

2.3 Location of the Data Link Connector (DLC)

The DLC (Data Link Connector or Diagnostic Link Connector) is typically a 16-pin connector
where diagnostic code readers interface with the vehicle's on-board computer. The DLC is
usually located 12 inches from the center of the instrument panel (dash), under or around
the driver's side for most vehicles. If Data Link Connector is not located under dashboard, a
label should be there telling location. For some Asian and European vehicles, the DLC is
located behind the ashtray and the ashtray must be removed to access the connector. If the
DLC cannot be found, refer to the vehicle's service manual for the location.

2.4 OBD II Readiness Monitors

An important part of a vehicle's OBD II system is the Readiness Monitors, which are
Creader 5001 English User's Manual
Figure 2-1
Figure 2-2
2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents