Cutting Tensioned Strap - Signode RCD-1431 Operation, Parts And Safety Manual

Use the correct Signode products for your application. If you need help contact your Signode
Representative.
Signode tools and machines are designed and warranted to work together with Signode
strapping and seals. Use of non-Signode strap, seals and/or manufactured or specified
replacement parts may result in strap breakage or joint separation while applying strapping
to a load or during normal shipping and handling. This could result in severe personal injury.
SAFETY PROCEDURES FOR TOOL OPERATION
1. OPERATION SEQUENCE.
Before using this tool, read its Operation and Safety Instructions contained in this manual.
2. This tool is a double reverse notch type sealer. A properly formed
joint will appear as shown in the illustration. An improperly formed
seal which does not have four good notches could result in strap
separation which can result in serious personal injury or death. If
the joint does not appear as shown, then the operator must proceed
as follows:
A. Ensure that the tool's operating instructions are being followed before
applying another strap.
B. Cut the strap off and apply another.
If the joint still does not appear as shown, then inspect the tool for worn and/or damaged
parts. Replace tool parts as needed. BEFORE MOVING ANY PACKAGE BE CERTAIN THAT
THE SEAL IS FORMED WITH FOUR GOOD NOTCHES AS SHOWN. Misnotched joints may not
secure the load and could cause serious injury.
3. Tuck strap end back into the dispenser when not in use.

CUTTING TENSIONED STRAP

FLYING STRAP HAZARD.
Using claw hammers, crowbars, chisels, axes or similar tools will cause tensioned strap to fly
apart with hazardous force. Use only cutters designed for cutting strap. Read the instructions in
the cutters manual for proper procedure in cutting strap. Before using any Signode product read
its Operation and Safety Manual.
3