5
Press
to select channel number to
map to the decoder/descrambler channel.
6
Press OK .
7
Press
to select and enter [Status] .
8
Press
to select the connector used by
the decoder/descrambler ( [None] , [EXT
1] or [EXT 2] .
9
Press OK .
10
MENU to exit.
Press
Note
•
Select
[None] if you do not want to map to the
decoder/descrambler channel.
•
[EXT 2] is available only in TVs of 26 inches and
larger.
Start a TV demo
1
MENU .
Press
2
Select [Features] > [Demo] .
[Demo] menu appears.
The
È
3
Press
to select a demo.
•
[Dig.CrystalClear] Displays two
pictures side by side on the screen
- a normal picture and a picture
enhanced by this feature.
•
[Active Control] Automatically
adjusts the picture setting for optimal
picture quality continuously under
any signal conditions.
4
Press OK to start the demo.
5
Press
MENU to exit.
Reset the TV to factory
settings
You can restore the default picture and sound
settings of your TV. Channel installation settings
remain the same.
1
Press
MENU .
2
Select [Installation] > [Factory settings] .
3
to enter the [Factory settings]
Press
menu.
È [Reset] is highlighted.
4
Press OK to reset to factory settings.
5
MENU to exit.
Press
EN
17