Access Decoder Channel; Start A Tv Demo; Reset The Tv To Factory Settings - Philips 32PFL3605/12 User Manual

Access decoder channel

You can map channels provided through a
decoder or descrambler to your TV channel
selection. In this way, you can select these
channels by using the RC of your TV. The
decoder or a descrambler must be connected
to EXT1 (SCART).
Set decoder channel
Map channels from a decoder or descrambler.
1
Press MENU.
2
Select [Setup] > [Installation] >
[Decoder].
3
Press to enter [Decoder] menu.
4
Press to select [Channel], then press
to enter.
5
Select one channel to map to the
decoder / descrambler channel and press
OK to confirm.
6
Select [Status], then press
7
Select [EXT 1] (SCART) the connector
used by the decoder / descrambler.
8
Press OK.
9
Press MENU to exit.
Note
• Select [None] if you do not want to map to
the decoder / descrambler channel.

Start a TV demo

You can use demonstrations to better
understand the features of your TV. Some
demos are not available on certain models.
Available demos are displayed in the menu list.
1
2
3
Reset the TV to factory
settings
You can restore the default picture and sound
settings of your TV. The channel installation
settings remain the same.
1
2
to enter.
3
4
5
6
Press DEMO on the remote control.
Press to select a demo and press OK
to view it.
Press BACK to exit.
Press MENU.
Select [Setup] > [Installation] >
[Factory settings].
Press to enter [Factory settings].
Select [Reset] to start resetting.
Press OK.
Press MENU to exit.
EN 21