Access Decoder Channel; Start A Tv Demo; Reset The Tv To Factory Settings - Philips 42PFL3605/60 User Manual

Access decoder channel

You can map channels provided through a
decoder or descrambler to your TV channel
selection. In this way, you can select these
channels by using the RC of your TV. The
decoder or a descrambler must be connected
to EXT1 (SCART).
Set decoder channel
Map channels from a decoder or descrambler.
1
Press MENU.
2
Select [Setup] > [Installation] >
[Decoder].
3
Press to enter [Decoder] menu.
4
Press to select [Channel], then press
to enter.
5
Select one channel to map to the
decoder/descrambler channel and press
OK to confirm.
6
Select [Status], then press
7
Select [EXT 1] (SCART) the connector
used by the decoder/descrambler.
8
Press OK.
9
Press MENU to exit.
Note
•
Select [None] if you do not want to map to
the decoder/descrambler channel.

Start a TV demo

You can use demonstrations to better
understand the features of your TV. Some
demos are not available on certain models.
Available demos are displayed in the menu list.
1
Press DEMO on the remote control.
2
Press to select a demo and press OK
to view it.
3
Press BACK to exit.
20 EN
to enter.
Reset the TV to factory
settings
You can restore the default picture and sound
settings of your TV. The channel installation
settings remain the same.
1
Press MENU.
2
Select [Setup] > [Installation] > [Factory
settings].
3
Press to enter [Factory settings].
4
Select [Reset] to start resetting.
5
Press OK.
6
Press MENU to exit.