Sending Cutting Data - GRAPHTEC CE LITE-50 Setup Manual

Performing Cut Tests
Perform cutting tests to verify that the blade depth and
cutting conditions are appropriate. Be sure to perform cutting
tests before cutting. For the details, please refer to the User's
Manual 5.5.

Sending cutting data

Create the cutting data with dedicated software, and send it
to the device to cut the media.
Responding to Trouble
When the device does not operate even when the
power is turned ON
Symptom Possible Cause
There is Power is not
nothing being supplied.
displayed on Otherwise, the
the LCD device may be
panel. broken.
The device is
broken.
Operation is Irregular
Symptom Possible Cause
The device The device may
could not have been
recognize the exposed to the
media. intense light.
The transparent
media has been
loaded.
There may be a
problem with the
Width detection
sensor.
There may be a
problem with the
device.
The media The push rollers
swerves. are not set
properly.
One of the The front side or
push rollers the rear side of
does not stay the media is not
on top of the cut straight in
media. relation to the
media.
4
Solution
Confirm that the power cable is
properly plugged in to the
connector on the device and an
AC outlet. Confirm that power is
coming to the AC outlet.
Contact your sales
representative or nearest
Graphtec dealer if the problem
still exists.
Solution
If direct sunlight is coming in
from a nearby window, block
the light. If a fluorescent lamp
stand is located nearby, move
this away from the device.
Disable Media width detection.
For the details, please refer to
the User's Manual 5.7.
Adjust the Width detection
sensor. For the details, please
refer to the User's Manual 6.4.
Contact your sales
representative or nearest
Graphtec dealer if the problem
still exists.
Confirm the positions of the
push rollers.
Cut the edge of the media
straight.