Husqvarna 226K Operator's Manual page 6

1. Push the throttle trigger lockout (A). Make sure that
the throttle trigger (B) is released.
B
2. Make sure that the throttle trigger (B) is locked at the
idle position when the throttle trigger lockout is
released.
3. Push the throttle trigger lockout (A) and make sure
that it goes back to its initial position when you
release it.
4. Make sure that the throttle trigger lockout (A) and the
throttle trigger (B) move freely.
5. Start the product and apply full throttle. Refer to
start the engine on page 10 .
6. Release the throttle trigger (B) and make sure that
the cutting attachment stops and stays stationary.
6
A
To
WARNING: If the cutting attachment moves
when the throttle trigger is in the idle
position, adjust the idle speed. Refer to
adjust the idle speed on page 12 .
To do a check of the stop switch
1. Start the engine.
2. Move the stop switch to the stop position and make
sure that the engine stops.
To do a check of the vibration damping system
The vibration damping system decreases vibration in the
handles to a minimum which makes the operation
easier.
1. Stop the engine.
2. Do a visual check for deformation and damage, for
example cracks.
To
1261 - 001 - 19.09.2019