Husqvarna 226K Operator's Manual page 12

Maintenance schedule
Maintenance
Clean the external surface.
Do a check of the throttle trigger lockout and the throttle trigger. Refer to
check of the throttle trigger lockout on page 5 .
Make sure that the harvest attachment does not move at idle speed.
Do a check of the stop switch. Refer to
6 .
Examine the handles for damages and make sure that they are attached correct-
ly.
Tighten the locking screw fully for harvest attachments.
Examine the engine, the fuel tank and the fuel lines for leaks.
Clean the air filter. Replace it if it is damaged.
Tighten nuts and screws.
Examine the starter and the starter rope for damages.
Examine the vibration damping units for damages and cracks.
Examine the spark plug. Refer to
Clean the cooling system.
Clean the external surface of the carburetor and the area around it.
Examine the fuel filter for contamination and the fuel hose for cracks and other
defects. Replace if it is necessary.
Examine all cables and connections.
Examine the clutch, clutch springs and clutch drum for wear. Replace it if it is
necessary.
Replace the spark plug.
Lubricate the drive shaft.
To adjust the idle speed
Your Husqvarna product is made to specifications that
decrease harmful emissions.
1. Make sure that the air filter is clean and the air filter
cover is attached before you adjust the idle speed.
2. Adjust the idle speed with the idle speed screw T
which is identified with "T" mark.
1
Replace the vibration damping unit after each season or at a minimum of one time each year.
2
At an interval of 3 months.
12
To do a check of the stop switch on page
To examine the spark plug on page 14 .
2
Daily
To do a
1
Weekly Monthly
X
X
X
X
X
X
X
X
X
X
X
X
X
X
1261 - 001 - 19.09.2019
X
X
X
X
X