Barco Data 1209s Installation Manual page 34

Repeat the same procedure for the red and blue image using the
corresponding screws.
To optimize the image focusing, repeat the optical lens focusing.
When the scheimpflug corrections are correctly adjusted, secure
this position by fastening the security screws on both sides of each
lens.
Warning : When the security screws are tightened, it is not possible
to change the scheimpflug correction.
After finishing the Installation Adjustment Procedures, the main menu
returns on the screen. You are now able to start the alignment
procedure for the projector.
For detailed information about these adjustments, please refer to the
Owner's Manual.
5975718 BARCODATA 1209s 050698
All manuals and user guides at all-guides.com
Installation adjustment mode
+
+
DIAGONAL IMAGE FOCUSING
from left bottom to right top
+
i ‚ y‡Ã6 %
i ‚ y‡Ã6
+
i ‚ y‡Ã6 "
i ‚ y‡Ã6 $
RED IMAGE
e.g. : Turning bolt A 5 will influence the diagonal focus for Red from left bottom to right top
ADJUSTMENT MODE
Select a path from
below:
GUIDED
RANDOM ACCESS
INSTALLATION
SERVICE
Select with
then <ENTER>
<EXIT> to return
+
+
LENS
CORNER FOCUSING
CENTER FOCUSING
DIAGONAL IMAGE FOCUSING
from left top to right bottom
+
i ‚ y‡Ã6 #
+
i ‚ y‡Ã6 !
BLUE IMAGE
GREEN IMAGE
IRIS
or
enter
password
xxxx
197
8-7