Product Safety Information; Product Specifications; Installation And Lubrication; Parts And Maintenance - Ingersoll-Rand 1720B Series Product Information

Product Safety Information

Intended Use:
These Air Impact Wrenches are designed to remove and install threaded fasteners.
For additional information refer to Product Safety Information Manual Form 04580916.
Manuals can be downloaded from ingersollrandproducts.com.

Product Specifications

Drive
Type of
Model
Handle
in.
1720B1 grip 3/4" sq. dr. 1,000
1720B3 grip 1" sq. dr.
1720P1 pistol 3/4" sq. dr. 1,000
1720P3 pistol 1" sq. dr.
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
*K= Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 04581666 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
03532983_ed13
Recommended
Impacts
Torque Range
per min.
ft–lbs (Nm)
200–600 (271–813)
1,000 250–750 (340–1016)
200–600 (271–813)
1,000 250–750 (340–1016)
WARNING
Sound Level dB(A)
(ISO15744)
† Pressure (L ) ‡ Power (L
p
97
97
98.1
98.1
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease - during assembly
11. Grease - through fitting
EN
Vibration (m/s²)
(ISO28927)
) Level *K
w
108 -- --
108 -- --
109.1 10.4 1.3
109.1 13.2 1.1
EN-1