Table of Contents
Advertisement
LAUNCH
Structures
Overall Structures
KWA-300 3D Wheel Aligner mainly consists of the
wheel aligner main unit, cameras and their posts,
wheel clamps, targets, communication cables,
mechanical turntables, steering wheel holder and
brake pedal depressor, etc.
Wheel Aligner Main Unit
The main unit is an operation control platform. It
consists of cabinet, computer group, interface circuit
system and power supply assembly, etc., as shown
in Fig.2.1.
Cameras and their posts
KWA-300 3D wheel aligner includes 4 CCD
cameras, which respectively capture the images
from the 4 targets attached on the vehicle wheels.
The cameras are mounted inside the steel housings
as shown in Fig. 2.2. The accurate calibration for
camera has been performed during first installation,
so it is not necessary for user to calibrate it when
using the instrument.
KWA-300 3D Wheel Aligner
Fig.2.1
The two posts KWA-300 3D wheel aligner are used
for containing and fastening the CCD cameras and
their signal cables. The two posts are respectively
mounted on the ground with anchor bolts, and the
position relationship between the posts and the
cabinet is as shown in Fig. 2.3.
(Note: No matter during or after using, ensure to
2-1
The computer group includes industrial computer,
monitor, keyboard, mouse, printer and image
collector, etc. The monitor, mouse and printer are on
the top of the cabinet. The industrial computer is
inside the upper compartment of the cabinet, the
image collector is inside the industrial computer and
the keyboard is installed on the keyboard drawer.
The power supply assembly includes power lead,
power socket, tube fuse and the power supply main
switch. The power supply master switch pushbutton
is installed at the upper part of the left sideboard of
cabinet, the tube fuse (AC220 5A) is installed at the
power supply socket, and the power supply socket
is at the lower compartment of the cabinet.
Fig.2.2
Structures
Advertisement
Table of Contents
