Table of Contents
Advertisement
LAUNCH
Functions and Features
Complete test: The KWA-300 3D Wheel
l
Aligner can be used to measure the most
wheel alignment parameters, such as front
wheel toe-in, front wheel camber, caster,
Kingpin inclination, maximal steering angle,
thrust angle, toe-out on turns, rear wheel
toe-in, rear wheel camber, thrust angle,
wheelbase difference, tread difference, etc.
Brand new 3D computer vision measurement:
l
automatically test the aligning angles with high
performance camera.
l
Positive targets: there are any electronic
elements inside the targets, and no cables
between the targets and the main unit, so the
targets are easy to be fastened on the wheel
Specification
Total toe-in
Camber
Caster
Kingpin Inclination
Maximal steering angle
Maximal rim size
Maximal wheelbase it can measure
Notes:
1.
The right of changing the design will be reserved by manufacturer;
2.
The above accuracy can be confirmed only when the user follows the specified operation procedures.
Requirements on Surroundings
Item
Ambient temperature
0~+50℃
Relative humidity
≤85%
No direct strong lights irradiate
Light requirement
the target and reflect to the
camera
The height difference
<1mm (left to right); <2mm
between the left rail
(front to back)
KWA-300 3D Wheel Aligner
Item
Specification
clamps.
l
Provides many kinds of auto test processes
and diagram operating interfaces, very simple
and clear to operate; the whole test process
can be performed automatically, and there are
some humanity tips on the corresponding
interfaces.
Complete databank: wheel alignment data of
l
over 20,000 vehicle models is stored in the
system. User can also add new data to the
databank.
l
Automatically record the history data, easy for
customer measurement.
Standard printer to print test result.
l
l
Provide real-time help with help system.
Resolution
±0.03º
±0.03º
±0.06º
±0.06º
±0.06º
and right rail of lift
Working Principle
The working framework of KWA-300 3D Wheel
Aligner is as shown in Fig.1.9. The whole system is
composed of data collecting system and data
processing system.
1-4
Introduction
Test Range
0~±20º
0~±20º
0~±25º
0~±25º
0~±30º
20 inches
4000mm
Advertisement
Table of Contents
