Table of Contents
Advertisement
LAUNCH
Precautions
l Please read the User's Manual and the
Installation and Parts Manual carefully before
operating KWA-300 3D.
l Only the qualified technician can operate the
Wheel Aligner.
l The operator must have knowledge of computer
application and basic theory of wheel
alignment.
l The power voltage of KWA-300 3D is
AC220V±10% 50±1Hz / AC110V±10% 60±1Hz
（ It can be customized according to the
requirements of
customer）. The 3-terminal
socket must be used, and the earth terminal
must be well grounded. If the power voltage is
not stable, please purchase and use AC voltage
stabilizer.
l Before installing 3D wheel aligner, the lift should
be installed at first according to the
requirements. Regularly check the lift for
fastening and leveling, ensuring the test
accuracy and personnel safety; Take away the
roadblocks around the lift to prevent influencing
operation.
l Don't place KWA-300 3D on a vibrated object or
an oblique surface. Avoid direct sunlight and
moisture.
l Turn off the power after operation. Check all
bolts and parts after maintenance, and tighten
the slackened bolts and parts in turn for safety.
l Using the computer visual technology, and
recognizing the targets mounted on the wheels
through the camera with high resolution, it is
necessary for KWA-300 3D to prevent the
outside infrared rays (e.g. sun-lights) from
directly lighting to the targets and reflecting to
the cameras, and it is necessary to avoid
blocking the light way from the targets and the
cameras for a long time during the instrument is
working.
l The targets of KWA-300 3D wheel aligner are
the key components for testing, do not damage
their structures when using and storing, keep
the surface of target clean. Please use the soft
cloth dipped with a appropriate amount of the
neutral detergent or the absolute alcohol to
wipe the surface of target lightly if there are
some smuts on it.
l The wires inside the cabinet and the camera
posts are connected compactly. Don't move
them after first installation.
l The precision position calibration has been
KWA-300 3D Wheel Aligner
performed for the cameras after first installation,
the user can not move or wobble the camera
post no matter during or after using it.
l If without approval of the supplier, please do not
disassemble the main unit and camera post in
order to avoid damaging the components,
influencing the test accuracy and increasing the
cost s and difficulties of maintenance and repair.
For the damage caused by un-ratified
disassembling will not be covered by the
Warranty.
l The fastening method should be selected
correctly and flexibly according to the actual
conditions of the rim, the turning force should
be equal when fastening, after fastening, please
pull the wheel clamp lightly to check it for
fastening and connect safety cord well.
l The force should be equal when using each
knob, please don't fasten it too tight in order to
avoid damaging the locking mechanism or other
parts.
l After using, please cut off all power supply
timely.
l The cameras of KWA-300 3D wheel aligner are
the key optical components for testing, do not
impact them when using, keep the surface of
the camera lens clean. Please use the lens
paper to wipe the surface of the camera lens
lightly if there are some smuts on it.
ii
Advertisement
Table of Contents
