Table of Contents
Advertisement
LAUNCH
Start Test
After all settings have been finished, you can perform
the wheel alignment test. Please click Start Test icon
in the Alignment Test interface, the instrument will
perform the test according to the test items and the
test methods set above.
System Calibration
Only the specialized person from Launch can perform
this kind of operation, it is not necessary for user to
do it. Please refer to KWA-300 3D Wheel Aligner
Installation and Parts Manual for details.
Target Monitoring
Target monitoring needs to performed before test,
click the icon of [Target Monitor], the screen will
display the interface as shown in Fig.4.27.
The upper column of the above interface is the
functional pushbutton display area, the middle part of
the interface is the target image display area, and the
bottom column of the interface is the target centers
position display area. The target monitoring interface
can display the four target images at the same time
(default interface), also it can display any one of the
four target images, you can select the image to be
displayed by clicking the corresponding functional
KWA-300 3D Wireless Wheel Aligner
Fig.4.26
Fig.4.27
pushbutton on the upper column of the interface. The
functional pushbuttons, such as Restore Target
Image, Zoom in Target Image, Zoom out Target
Image and Move Target Image, etc. are available only
in case of the single target image is displayed.
If the grey scale of the target can not be distinguished,
please adjust the target and its corresponding camera
in order to let the target be on the appropriate
position.
Check Test Result
Click the icon of [Check Test Result] in the main
interface, the screen will display the interface as
shown in Fig.4.28.
This function is used to check the data saved in the
previous test, e.g. after finishing the test for the single
wheel, the screen will not display the test result, you
can check the test result by entering this function
interface. Click
adjustment result interfaces; click [Exit] pushbutton to
return to the previous interface.
Language Setting
Click [Language Setting] icon on the main interface,
the screen will display language setting dialogue box
as shown in Fig.4.29:
4-7
Operation Instructions
Fig.4.28
pushbutton to change over the
Fig.4.29
Advertisement
Table of Contents
