LAUNCH TECH LAUNCH KWA-300 Manual page 8

LAUNCH KWA-300 3D Wheel Aligner Introduction
Right camera Right target
Monitor
Industrial computer, image collector
Printer
Left camera Left target
keyboard、mouse
Fig.1.9
The data collecting system consists of 4 cameras
with high resolution and 4 targets. The left and right
cameras capture the images on the left and right
targets, and transmit them to the data processing
system via the image collector. The targets are
attached on the wheel rims via wheel clamps. So
the geometrical relationships among 4 wheel rims
are calculated according to the images captured by
cameras from the targets and further to confirm the
aligning parameters of the wheels.
The data processing system is the main unit of
KWA-300 3D. It consists of an industrial computer,
power supply system and interfaces. Its function is
to execute the operation commands, process the
data and display the information together with the
original data of vehicle manufacturer. It also gives
instructions for making adjustment to the vehicle
and print out corresponding report.
The wheel aligner compares the measured results
with the original data of vehicle manufacturer and
gives instructions to the user for adjustment, so its
databank should contain enough information.
KWA-300 3D Wheel Aligner contains wheel
alignment databank of over 20,000 vehicle types all
over the world. User can also add new vehicle
wheel alignment data in the databank when
necessary.
1-5