Table of Contents
Advertisement
LAUNCH
Maintenance
To prolong the life of the equipment, the user should
maintain it with care. The Wireless Wheel Aligner is
a precision equipment, that requires periodical
maintenance.
Computer
User should have a basic knowledge about
l
computer software and hardware to insure the
normal operation of the computer.
The main unit and the monitor should be firmly
l
secured on the desk. Do not put them in a
freezing, wet, extremely hot or direct sunlight
place, or near the source of radiation and heat.
l
Don't foist anything into the main unit and the
monitor through the gap.
l
Don't move the computer during operation.
Do not switch on/off the computer too
l
frequently.
l
Don't change the BIOS setting at will.
l
Don't delete the unknown files in the hard disc
at will to avoid abnormal computer operation or
death.
The computer is used only for the Wireless
l
Wheel Aligner; don't install other software to
the Wireless Wheel Aligner computer to avoid
computer virus. The computer is scanned to
ensure it is free of virus before leaving factory.
Don't use other software to avoid possible
l
virus. LAUNCH warranty does not cover the
system problem arising from the virus.
After a long period of use, the dust and oil dirt
l
will be accumulated on the main unit and the
monitor. Please cleanout it with neutral
detergent or dehydrated alcohol. Avoid using
oil or caustic product.
Never disassemble the computer and move
l
the inside cables and cards to avoid damage
of the inside components.
Wheel Clamp and Target
The wheel clamp should be cleaned and oiled
l
timely to insure that the span of claws can be
easily adjusted and attached.
l
The targets of KWA-300 3D wheel aligner are
the key components for testing, do not damage
their structures when using and storing, keep
the surface of target clean. Please use the soft
cloth dipped with a appropriate amount of the
neutral detergent or the absolute alcohol to
wipe the surface of target lightly if there are
some smuts on it.
KWA-300 3DWireless Wheel Aligner
Printer
Posts and signal cables
Turntables
6-1
Don't disassemble the targets and clamps to
l
avoid damage of their elements. LAUNCH will
not guarantee for this kind of failure.
l
Read the operation instruction of the printer
carefully.
l
Install suitable printer drive program, and apply
right printer setting.
If the printed words are not clear, it may be that
l
the ink is used out. Please replace the printer
ink cartridge in time to resume the printing
quality.
l
For other printer related problems, please
contact the customer service center.
l
There are two precision CCD cameras inside
the posts. The precision position calibration
has been performed for the cameras after first
installation. The user can not move or wobble
the camera post no matter during or after using
it.
l
Using the computer visual technology, and
recognizing the targets mounted on the wheels
through the camera with high resolution, it is
necessary for KWA-300 3D to prevent the
outside infrared rays (e.g. sun-lights) from
directly lighting to the targets and reflecting to
the cameras, and it is necessary to avoid
blocking the light way from the targets and the
cameras for a long time during the instrument
is working.
l
The wires inside the cabinet and the camera
posts are connected compactly. Don't move
them after first installation.
l
If without approval of the supplier, please do
not disassemble the main unit and camera
post in order to avoid damaging the
components, influencing the test accuracy and
increasing the cost s and difficulties of
maintenance and repair. For the damage
caused by un-ratified disassembling will not be
covered by the Warranty.
The electronic turntables are precision components.
Avoid hitting during operation and never splash
water on them.
When moving the vehicle on the turntable, please
insert the locking pin to avoid the turntable sliding.
Maintenance
Advertisement
Table of Contents
