Maintenance, Precautions - Chicago Pneumatic CP 0016 Safety And Operating Instructions Manual

CP 0016, 4130, 4131, 4132, 4134
Immediately stop working if the machine
►
suddenly starts to vibrate strongly. Before
resuming the work, find and remove the cause
of the increased vibrations.
Never grab, hold or touch the inserted tool
►
when using the machine.
Participate in health surveillance or monitoring,
►
medical exams and training programs offered
by your employer and when required by law.
When working in cold conditions wear warm
►
clothing and keep hands warm and dry.
The exhaust air is strongly chilled and shall not
►
make contact with the operator. Always direct
the exhaust air away from hands and body.
See the "Noise and vibration declaration
statement" for the machine, including the declared
vibration values. This information can be found at
the end of these Safety and operating instructions.
Comply with the recommended air-pressure
◆
when operating the machine. Either higher or
lower air-pressure has the potential of resulting
in higher levels of vibration.
DANGER Electrical hazard
The machine is not electrically insulated. If the
machine comes into contact with electricity, serious
injuries or death may result.
Never operate the machine near any electric
►
wire or other source of electricity.
Make sure that there are no concealed wires or
►
other sources of electricity in the working area.
WARNING Concealed object hazard
During operating, concealed wires and pipes
constitute a danger that can result in serious injury.
Check the composition of the material before
►
operating.
Watch out for concealed cables and pipes for
►
example electricity, telephone, water, gas and
sewage lines etc.
If the inserted tool seems to have hit a
►
concealed object, switch off the machine
immediately.
Make sure that there is no danger before
►
continuing.
WARNING Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
9800 0616 71 | Original instructions
Safety and operating instructions
Learn how the machine is switched off in the
►
event of an emergency.
Release the start and stop device immediately
►
in all cases of power supply interruption.
Whenever fitting or removing the working tool,
►
switch off the air supply, bleed the machine by
pressing the start and stop device and
disconnect the machine from the power source.
WARNING Noise hazard
High noise levels can cause permanent and
disabling hearing loss and other problems such as
tinnitus (ringing, buzzing, whistling or humming in
the ears). To reduce risk and prevent an
unnecessary increase in noise levels:
Risk assessment of these hazards and
►
implementation of appropriate controls is
essential.
Operate and maintain the machine as
►
recommended in these instructions.
Select, maintain and replace the working tool as
►
recommended in these instructions.
If the machine has a muffler, check that it is in
►
place and in good working condition.
Always use hearing protection.
►
Use damping material to prevent work pieces
►
from "ringing".

Maintenance, precautions

WARNING Machine modification
Any machine modification may result in bodily
injuries to yourself or others.
Never modify the machine. Modified machines
►
are not covered by warranty or product liability.
Always use approved original parts, tools, and
►
accessories.
Change damaged parts immediately.
►
Replace worn components in good time.
►
CAUTION Hot working tool
The tip of the working tool can become hot and
sharp when used. Touching it can lead to burns
and cuts.
Never touch a hot or sharp working tool.
►
Wait until the working tool has cooled down
►
before carrying out maintenance work.
11