Table of Contents
Advertisement
Safety and operating instructions
WARNING
Noise hazard
High noise levels can cause permanent and disabling
hearing loss and other problems such as tinnitus
(ringing, buzzing, whistling or humming in the ears).
To reduce risk and prevent an unnecessary increase
in noise levels:
►
Risk assessment of these hazards and
implementation of appropriate controls is
essential.
Operate and maintain the machine as
►
recommended in these instructions.
►
Select, maintain and replace the insertion tool as
recommended in these instructions.
If the machine has a muffler, check that it is in
►
place and in good working condition.
Always use hearing protection.
►
Use damping material to prevent work pieces
►
from "ringing".
Maintenance, precautions
WARNING
Machine modification
Any machine modification may result in bodily
injuries to yourself or others.
►
Never modify the machine. Modified machines
are not covered by warranty or product liability.
Always use original parts, insertion tools, and
►
accessories.
Change damaged parts immediately.
►
Replace worn components in good time.
►
CAUTION
Hot insertion tool
The tip of the insertion tool can become hot and
sharp when used. Touching it can lead to burns and
cuts.
Never touch a hot or sharp insertion tool.
►
►
Wait until the insertion tool has cooled down
before carrying out maintenance work.
WARNING
Working tool hazards
Accidental engagement of the start and stop device
during maintenance or installation can cause serious
injuries, when the power source is connected.
Never inspect, clean, install, or remove the
►
working tool while the power source is
connected.
Storage, precautions
Keep the machine and tools in a safe place, out
♦
of the reach of children and locked up.
10
9800 0548 90b | Original instructions
CP 0012
Advertisement
Table of Contents
