Daikin BACnet Series Installation Manual page 12

Program Set-Up
Procedure
Change the override setpoint
Change the display units
IO-DAPPS
Steps
Entering an override setpoint can only take place if the BACnet™
Thermostat is in the unoccupied mode.
1. Push the button under unoccupied icon .
NOTE: If a user password has previously been set up with a user
password, entering a password is not required.
2. Press either the ▲ or ▼ button to change the first digit of the
password.
3. Press the Enter button to select the next digit of the password.
4. Press either the ▲ or ▼ button to turn the override ON or OFF.
• Override Off – The controller uses the unoccupied setpoint as
the active setpoint
• Override On – The controller changes to the occupied setpoint
which can then be temporarily changed
5. Press the Enter button to save the setting.
NOTE: When the system is in the unoccupied mode, changing the
active setpoint will automatically place the system in the override
mode.
To temporarily change the display units to either Celsius or
Fahrenheit, press and hold the middle button under the display until
the units change.
www.daikinac.com
Display
12